|
|
|
|
|
|
|
|
|
|
|
|
33 Glen Cameron Rd Unit 8
Thornhill, Ontario L3T 1N9
Tel: 905 889-5237
Fax: 905 889-4818
Email: ims@imscanada.com
|
| Manufacturers
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| High Pressure Fluid Connections from StoneAge Waterjet Tools |
High Pressure Connections
High Pressure Fluid Connections Info
For Lances, Shafts, and Extension Nipples.
|
 |
 |
Pipe Threads
- Tapered threads make both pressure seal and mechanical connection.
- Rated to 15 Kpsi in sizes up to 3/4 in pipe.
- Thread sealant and anti-seize required.
- The most economical connection.
- Used for lances, shafts, and extension nipples.
|
Cone & Thread - MP & HP
- Rated 20 Kpsi (MP), 60 Kpsi (HP).
- Requires gland and collar to connect.
- Available for 3/8, 9/16, & 3/4 in. OD tubing.
- Used for lances, shafts, and extension nipples.
- Right hand thread sometimes used to connect lance tips without gland or collar.
|
 |
 |
J-Shaft
- Special StoneAge design for BJV-20K shaft to head.
- 1.1 in. OD shaft with O-ring gland seal.
- Rated to 20 Kpsi design.
|
K-Shaft
- Special StoneAge design for SG & FS shaft.
- 1.1 in. OD shaft with O-ring face seal.
- Rated to 20 Kpsi design.
|
 |
|
|
 |
G12-Thread
- Special StoneAge design for 3/4"MP extension nipples.
- Requires SA 059 O-Ring.
- 1/4npt on other end.
- Rated to 20 Kpsi design.
|
|
 |
| Medium Pressure Cone & Thread
Tubing is prepared with 60 Deg cone which makes metal-to-metal seal, and left hand threads to accept a compression collar. A gland nut secures the collar. An anti-vibration gland is used in place of the standard gland in applications where vibration or potential bending might over-stress or fatigue the tubing threads. When the gland is loosened, any residual pressure is relieved through a port hole drilled near the cone seal. “MP” connections are available in 1/4”, 3/8”, 9/16”, 3/4”, and 1” OD tubing sizes. It is rated to 20,000 psi. Right-hand threads are sometimes used to connect lance tips without the collar or gland.
|
|
|
|
|
|
|
|
|
|
|
